(Madison County Lake Specific)
0 messages
Updated
Lakes Online Forum
84,091 messages
Updated 11/8/2024 10:28:12 AM
Lakes Online Forum
5,204 messages
Updated 9/14/2024 10:10:50 AM
(Madison County Lake Specific)
0 messages
Updated
Lakes Online Forum
4,172 messages
Updated 9/9/2024 5:04:44 PM
Lakes Online Forum
4,262 messages
Updated 11/6/2024 6:43:09 PM
Lakes Online Forum
2,979 messages
Updated 6/26/2024 5:03:03 AM
Lakes Online Forum
98 messages
Updated 4/15/2024 1:00:58 AM
|
|
|
Name: |
Haltstep
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/8/2012 8:08:54 PM
|
Hey Cat!
Just purchased a used 2003 Yamaha FX140 waverunner with 170 hours. Max speed is 37 mph and 7500 rpm in water so I replaced NGK spark plugs, but still same problem. RPM will hit 10000 sitting on the trailer, but I will only run it for a few seconds. Engine runs smooth at idle and while accelerating---just poor top end performance. Any ideas on where to go from here in troubleshooting?
|
Name: |
GoneFishin
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/8/2012 9:15:19 PM
|
I make an appointment and drop it off at Cats.
|
Name: |
Kizma Anuice
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/8/2012 9:55:13 PM
|
Have you cHanged the fuel filters?
|
Name: |
Ulysses E. McGill
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/9/2012 12:35:14 AM
|
Is that off the speedo or a gps? Speedo may be wrong or clogged. If your getting that kind of RPM and the speedometer is correct, you may have a damage impeller or something restricting water flow in the intake.
|
Name: |
CAT BOAT
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/9/2012 9:32:26 AM
|
I have very limited experience with Yamaha FX140 PWC. I'll take a shot at the question though. Your 7500 rpm sounds just fine, however that would yield a lot more speed than 37mph. I have scene this problem once before. Impeller clearances were perfect and everything about the pump looked fine. However, it had excessive cavitation and pump slip. There is a seal kit available for the pump unit and ride plates. It required a little bit of time to install, but afterwards the FX ran great. Best I remember, it ran around 70????? I don't remember what top end was before we made the repairs, but it was not good. I just saw that customer the other day, and remember his name. I will look in his file and get my research notes and read through them. If you want, you can call me later today. I am at Lake Martin Shop. 256-825-3388. I will share that information with you.
Respectfully, Steve
|
Name: |
houseboat
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/9/2012 10:50:18 AM
|
Does it have a reverse? If so, is it part way in neutral? Talk to the previous owner about why he sold it.
|
Name: |
Ulysses E. McGill
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/9/2012 12:54:46 PM
|
If it's not a bad speedo, I agree with Steve that this could be the problem. I had something similar on one of mine a few years back, but you could hear the cavitation taking place. Houseboat also makes a good point of something to check. What ever it is, I'm sure Steve can figure it out.
|
Name: |
Summer Lover
-
|
|
Subject: |
Hey Cat!! Yamaha FX140 Wave Runner
|
Date:
|
5/9/2012 1:30:44 PM
|
You may want to try taking the PWC off the trailer when you put it in the water - having that thing underneath when you are trying to ride will slow you down.
|
|
|